20060318, 05:31  #1 
Oct 2004
Austria
2×17×73 Posts 
Why does it do only one curve?
I have installed msys and gmpecm as described in the readme file and tried to do some curves on the C205  entered this line:
ecm c 372 1e6 <1701c205 >1701c2051M.out I intended to get 372 curves, but I got only one. What did I do wrong? 
20060318, 17:52  #2 
Oct 2004
Austria
2×17×73 Posts 
Anyone help me how to get more than one curve?

20060318, 18:11  #3 
Jul 2004
Potsdam, Germany
3·277 Posts 
I just tried to retrace your problems. The only scenario I got such a behavior was when a factor has been found and the cofactor is probable prime.
Could you post your output file, please? 
20060318, 19:24  #4 
Oct 2004
Austria
4662_{8} Posts 
Here it is  I renamed it to .txt for uploading.
I see no factor in this file  it only gives the time steps one and two took. 
20060318, 21:23  #5 
Jul 2004
Potsdam, Germany
3×277 Posts 
Unfortunately, I wasn't able to reproduce your problem. I tried the same number with the same command line, but it worked for me.
I could think of two more problem sources: 1. Maybe there is something wrong with input/output. Just enter the number at command line ("echo <number>  ecm <...>") and don't redirect the output to a file. 2. Maybe your ecm file is somehow corrupt. Try recompiling it or take a suitable binary from this thread. Hope this helps! 
20060318, 22:28  #6 
Jun 2003
4,861 Posts 
If the input file doesn't have a terminating newline character after the number, gmpecm will quit after the first curve. Just add a newline to your input file and you should be ok.
Last fiddled with by axn on 20060318 at 22:28 
20060319, 06:38  #7  
Oct 2004
Austria
2·17·73 Posts 
Quote:


Thread Tools  
Similar Threads  
Thread  Thread Starter  Forum  Replies  Last Post 
Elliptic Curve Arithmetic  Raman  Math  8  20090413 19:20 
Lucky gmpecm curve...  WraithX  GMPECM  4  20090112 16:29 
Work Per ECM Curve  wblipp  GMPECM  8  20081228 14:24 
Elliptic curve method  Dirac  Factoring  11  20071101 14:01 
Curve Counts  Prime95  Factoring  23  20050322 16:43 