20220814, 22:19  #1 
"Evan"
Dec 2020
Montreal
124_{8} Posts 
sopt binary only processing the first polynomial
Hello! I'm currently getting all of my factoring utilities set up again, but I'm running into a really strange issue with CADO's sopt. For some reason, using a file with ~20k unique polynomials, sopt looks to only run on the first one, then keeps repeating optimization on the first optimized polynomial.
poly file contents sopt output more sopt output 
20220814, 22:42  #2 
Apr 2020
929 Posts 
Reproduced, this is a genuine bug. It's not there in revision 7eb15697 from last November so must have been introduced since then. Rolling back to that revision should sort you out for now.
Would you like to report this to the CADO mailing list or shall I? 
20220814, 23:35  #3  
"Evan"
Dec 2020
Montreal
2^{2}×3×7 Posts 
Quote:
you do it, I'm not really all too sure how to work with that :P (should probably figure it out eventually though) 

20220904, 20:28  #5 
Apr 2020
929 Posts 
Bug is now fixed, if you hadn't seen already.

Thread Tools  
Similar Threads  
Thread  Thread Starter  Forum  Replies  Last Post 
Binary polynomial transformation modulo p  carpetpool  Miscellaneous Math  16  20180531 20:43 
Polynomial Discriminant is n^k for an n1 degree polynomial  carpetpool  Miscellaneous Math  14  20170218 19:46 
Only 25% Processing Power???  JVD  Information & Answers  4  20120519 05:05 
Would you use a 'fat binary' of GMPECM?  jasonp  GMPECM  8  20120212 22:25 
Post processing for 2,757  xilman  NFSNET Discussion  3  20031106 14:23 