View Single Post
Old 2012-12-20, 15:20   #3
swl551
 
swl551's Avatar
 
Aug 2012
New Hampshire

23·101 Posts
Default

Quote:
Originally Posted by LaurV View Post
Yes.
IIRC, the message "Mxxx has a factor yyy bla bla bla" is said when a factor is found, and the class is finished, and at the end (when the bitlevel or the full assignment is finished, depending on the split) it says how many factors were found. So, if there are two factors (or more) at the same bitlevel, or even in the same class, and if your .ini file or command line switches does not instruct the mfaktc to stop immediately after a factor is found, then yes, at the end you will get "Found 2 (3, 4, etc) factors for Mxxx bla bla".

Thank you!
swl551 is offline   Reply With Quote