mersenneforum.org - View Single Post - Reserved for MF

EdH · 2016-09-30, 02:09

Rough calculations across all my machines working on the c162 put me at about:

Code:

  740 @ 11e3
 2140 @ 5e4
 4300 @ 25e4
 9040 @ 1e6
23500 @ 3e6
 6500 @ 11e6
  800 @ 43e6
  100 @ 11e7

Questions:

Were the grossly overdone (10x) smaller B1 values wasted?

Is there any reason to let the machines that are performing the YAFU ECM steps continue with the 11e6 work?

Is 7500 a good figure for 43e6?

Is 7000 a good figure for 11e7?

How do I tell what t value I'm current at?

What t value should I strive for?

Thanks!

2016-09-30, 02:09	#298
EdH "Ed Hall" Dec 2009 Adirondack Mtns 2·23·79 Posts	Rough calculations across all my machines working on the c162 put me at about: Code: 740 @ 11e3 2140 @ 5e4 4300 @ 25e4 9040 @ 1e6 23500 @ 3e6 6500 @ 11e6 800 @ 43e6 100 @ 11e7 Questions: Were the grossly overdone (10x) smaller B1 values wasted? Is there any reason to let the machines that are performing the YAFU ECM steps continue with the 11e6 work? Is 7500 a good figure for 43e6? Is 7000 a good figure for 11e7? How do I tell what t value I'm current at? What t value should I strive for? Thanks!